If you want to run a eCos microwindows application and encounter following messages:
No Video BIOS information at location 0x000A0000
Please use a suitably configured RedBoot for bootstrap
That means you may need a redboot with some additional configuration.
Go to "i386 PC Motherboard Support"->"Switch the display to an alternative video mode", check and key in available VESA video mode value, eg. 0x100.
You may need to check "i386 PC Target"->"Load into higher memory", to run some big program.
After you built out the redboot.elf, you should use COM to talk to it.(384008N1)
[Note] VESA 2.0 support only??
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment